Have decided to post some pix of my work on New South Wales Golf Club. Have been struggling with motivation, haven't worked on it at all this year until a few weeks ago, so thought doing this might help!
Its another Sydney metropolitan course, this one perched above the Pacific Ocean in La Parouse. There are some pretty spectacular ocean holes, so hope I can capture that in my APCD design. This is also another Linkster DEM.
With this course, it is all completely mapped out and textured. Now I just work hole-by-hole and try and fully complete each one before moving to the next. I like to add as much detail as possible and make a genuine attempt about replicating everything I can about the course (or what's possible).
With Royal Sydney, the clubhouse was finished early on in the design. This time, I will leave it to the end. No choice but to build it, because the first tee is right outside the front door. It will take some time but its quite a straightforward 3D build.
(For the best view, right-click the image and open in a new tab).
- Driveable opening hole
- NSWGCH1a.jpg (724.63 KiB) Viewed 679 times
- Hole 2 - the first of 4 Par 3s
- NSWGCH2a.jpg (730.15 KiB) Viewed 679 times
- Not sure about the planting - plenty of time to junk it if needed
- NSWGCH2b.jpg (644.63 KiB) Viewed 679 times
- Alot of waste sand and sandy rough in this course as was built on dunes
- NSWGCH3b.jpg (686.59 KiB) Viewed 679 times
- The approach to Hole 3
- NSWGCH3c.jpg (591.9 KiB) Viewed 679 times
- The clubhouse!
- NSW-golf-club-feature-image-2048x619.jpg (418.19 KiB) Viewed 676 times
Super fine work...!!!!!! I am ultimately impressed...!!!!!
The only diversions are due to APCD limitations (e.g. the round buildings) but they are minor anyway. The first image shown is basically a 3D rendition of the architectural plans.